CHAPTER 2
Unpacking and Inspecting the Dyno
Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
2-2
UNPACKING AND INSPECTING THE DYNO
When you receive your dyno, examine the exterior of the shipping container for any
visible damage. If damage is detected at this stage, contact the shipper or Dynojet
before proceeding with unpacking.
Use the following steps to unload your dyno. You will need to provide equipment
capable of lifting a minimum of 1,133.98 kg (2,500 lbs.) to move the crated dyno into
position in your dyno room. Refer to “Forklift Requirements” on page 1-9 for more
information.
1 Move the crated dyno to a clear area near your dyno room.
2 Using a pry bar, or a large flat screwdriver, and a hammer, remove the top and
sides of the crate.
3 Inspect the exterior of the dyno for any indications of damage. Report any damage
immediately.
4 Remove the tire carriage. The tire carriage is fastened to the bottom of the crate.
5 Remove the support arm. The support arm is fastened to the bottom of the crate.
Refer to“Monitor Support and Tray” on page 2-49 for more information.
Figure 2-1: Remove the Tire Carriage and Support Arm from the Crate
To Next Page
Loading...