2-53
INSTALLATION
Final Adjustments and Tests
Version 2 Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
FINAL ADJUSTMENTS AND TESTS
After you have installed all of your additional accessories and routed all necessary
cables, perform the following procedures to ensure the safe and effective operation of
your dyno.
Note: Before you plug in your dyno, you or your electrician must refer to
Appendix B for detailed power information.
TURNING ON THE DYNO POWER
1 Plug the power plug into the power outlet.
2 Turn on the main circuit breaker inside the CPI door.
Note: Use the main circuit breaker to turn power on and off to the dyno.
Figure 2-46: Turn on the Dyno Power
power plug
main circuit
breaker
To Next Page
Loading...
Need help?
General