C-3
EEC KIT INSTALLATION
EEC Finger Guards Installation
Version 2 Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
INSTALLING THE EEC FINGER GUARDS
Use the EEC finger guards P/N 21229105 with the dyno drum module hood and the
longer EEC finger guards P/N 21200073 with the iX drum module hood.
1 Secure each EEC finger guard to the drum module hood using two
1/4-20 x 5/8-inch pan-head torx screws.
Figure C-2: Secure the EEC Finger Guards—200i/250i and 200iX/250iX
2 Secure the drum module hood with the EEC finger guards to the dyno using the
eight screws removed earlier.
3 Secure the iX drum module hood with the EEC finger guards to the dyno using the
eight screws removed earlier.
4 Adjust the EEC finger guards. Refer to “Adjusting the EEC Finger Guards” on page
C-4.
Do not operate the dynamometer without the EEC finger guards properly
installed. The gap between the finger guards and the drum must be less
than 0.64 centimeters (0.25 inches). Refer to page C-4 for instructions on
adjusting the gap.
finger guard
dyno drum module hood
iX drum module hood
To Next Page
Loading...
Need help?
General