Dynojet 200iX - Installing the Dynoware RT Main Module

CHAPTER 2
Cable Routing
Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
2-34
INSTALLING THE DYNOWARE RT MAIN MODULE
You will need the following part:
• 66100016 DynoWare RT Main Module
Slide the DynoWare RT main module into the bracket assembly in the dyno.
Figure 2-27: Install the DynoWare RT Main Module
T - 76951501 control panel cable connects the control panel (POD) to J3 on the POD
intercept board
U - 76423025 PCV CAN termination plug connects to the PCV module when connected to the
DynoWare RT using the CAN Powersports cable
V - 76423045 CAN termination plug connects to the last CAN cable in the CAN network
cable chain
cable brief routing description
MC154