APPENDIX D
Ramp Installation—iX Upgrade
Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
D-10
RAMP INSTALLATION—IX UPGRADE
The iX folding ramp (P/N 82900000) allows you to easily and safely load wider
vehicles such as ATVs onto the dyno. This section will walk you through removing the
ramp from the crate and installing the ramp on model 200iX and 250iX motorcycle
dynos.
Verify the dyno ramp is in place and secured to the dyno before beginning with the iX
upgrade ramp installation. Refer to “Ramp Installation—Dyno” on page D-2.
You will need the following parts:
• 21200029 Tie-Down Hook Plate
• 21200039 Ramp Top Cover
• 21200047 Ramp Panel
• 36561045 Screw, 1/4-20 x 5/8”, PH, Torx (8)
• 61300011 Folding Ramp Option
• DM150-020-005 Nut, Crush, 1/4-20 (8)
1 Remove the two existing 3/8-16 x 1.25-inch screws from the back of the iX drum
module.
2 Remove the two existing 1/4-20 x 5/8-inch screws from the top of the iX drum
module.
3 Slide the ramp up to the iX drum module.
4 Secure the ramp to the iX drum module using the screws removed earlier.
Figure D-10: Securing the Ramp to the iX Drum Module
existing screws from the back of
the iX drum module
existing screw from the top
of the iX drum module
dyno ramp
ramp
To Next Page
Loading...