Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
1-2
INTRODUCTION
Before installing your dyno, please take a moment to read this guide for installation
instructions, dyno features, and other important information.
This guide is designed to be a reference tool in your everyday work and includes the
following chapters and information:
SPECIFICATIONS AND OPERATING REQUIREMENTS
This chapter describes the requirements and specifications for the dyno.
INSTALLATION
This chapter describes the procedures for installing the dyno.
ACCESSORIES
This chapter lists each dyno accessory alphabetically and describes the procedures for
installing and using the accessory.
CONTROL PANEL INTERFACE OPERATION
This chapter describes the Control Panel Interface (CPI) operating procedures.
BASIC DYNO OPERATION
This chapter describes basic dyno operating procedures.
RED HEAD INSTALLATION
This appendix describes the procedures for installing the Red Head anchors.
POWER REQUIREMENTS
This appendix describes the power requirements and installation instructions for the
dyno.
EEC FINGER GUARD & DOOR SAFETY SWITCH KIT
This appendix describes the procedures for installing the EEC finger guards and door
safety switch.
FOLDING RAMP INSTALLATION
This appendix describes the procedures for installing the folding ramp assemblies for
the dyno and iX upgrade.
ABOVE GROUND IXW INSTALLATION
This appendix describes the procedures for installing the above ground iXW upgrade
kit.
TORQUE VALUES
This appendix describes standard and metric torque values.
To Next Page
Loading...
Need help?
General