Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
2-38
ROUTING THE POWER CARRIAGE AND WHEEL CLAMP CABLES
The power carriage and wheel clamp are optional accessories. These cables will only
be used if you ordered the accessories.
For installation instructions refer to “Power Carriage” on page 3-24 and “Wheel
Clamp” on page 3-27 for more information.
You will need the following part:
• 43991080 Split Snap Bushing (2)
1 Remove the two screws securing the cable pass through cover on the front of the
dyno and set aside.
2 Locate the cables bundled inside the dyno.
3 Route the power carriage cable (H) and wheel clamp cable (G) through the
opening in the front of the dyno.
Figure 2-30: Remove the Cable Pass Through Cover
route cables
through
cable pass through
cover
To Next Page
Loading...
Need help?
General