E-5
ABOVE GROUND IXW INSTALLATION
Above Ground iXW Upgrade Installation
Version 2 Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
ABOVE GROUND IXW UPGRADE INSTALLATION
When you receive your iXW upgrade kit, examine the exterior of the shipping
container for any visible damage. If damage is detected at this stage, contact the
shipper or Dynojet before proceeding with unpacking.
Use the following steps to unload the iXW drum module and related items. You will
need to provide equipment capable of lifting a minimum of 363 kg. (800 lb.) to move
the crated drum into position in your dyno room.
REMOVING THE ITEMS FROM CRATE
1 Move the crate to a clear area near your dyno room.
2 Using a pry bar, or a large flat screwdriver, and a hammer, carefully remove the
top and sides of the crate.
3 Remove the following parts from the crate and set aside.
part description part description
drum safety cover
P/N 21200038
installation tool, redhead
anchor
P/N 37518200
side cover, short
P/N 21200143
woodruff key, 3/8 x 1-3/8"
#1211 (2)
P/N 37620622
middle bulkhead, iXW
P/N 21200198
monitor support brace
P/N 61300007
front bulkhead, iXW
P/N 21200202
fan arm mount (2)
P/N 61300009P
see page 2-44
left cover, iXW
P/N 21200205
iXW drum module
P/N 62100010
with P/N 21200025,
21200143, 21200203,
21229106, 61100028,
71300004 installed
To Next Page
Loading...
Need help?
General