2-19
INSTALLATION
Eddy Current Brake
Version 2 Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
INSTALLING THE EDDY CURRENT BRAKE
The eddy current brake comes with the driveline assembly (coupler) already installed
on the brake shaft.
Note: Safety requirements of your local country may require that both the air
brake and eddy current brake are installed. Be sure to follow the safety
requirements specific to your country.
1 Insert the key into the keyway.
2 Use a c-clamp to press the key in, if necessary.
Figure 2-14: Install the Key
key way on dyno shaft
key
connector plate
To Next Page
Loading...