5-3
BASIC DYNO OPERATION
Loading the Vehicle
Version 2 Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
5 When the vehicle is positioned properly on the dyno, shut the engine off.
• If the vehicle has an automatic transmission, place it in park.
• If the vehicle has a manual transmission, place it in gear.
6 Attach two tie-down straps from the ground hooks to the rear of the vehicle.
7 Attach two tie-down straps from the ground hooks to the front of the vehicle.
Note: If you are running an all wheel drive ATV, use differential jacks to get the
front wheels off the dyno.
Note: When running an ATV, you may need to increase the tire pressure so the
tire does not come in contact with the decking.
8 Tighten the four tie-down straps evenly making sure the drive wheels remain
centered on the drum.
Never perform a dyno run if the tie-down straps are not in place or they
are damaged.
Figure 5-2: Load the Vehicle—Top View
To Next Page
Loading...