4 PKE-SWD-32, interface for motor-starter combination with PKE PKE12/32
4.6 Exchange of modules
108 SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com
4.6 Exchange of modules
After replacement of the modules and connection of the voltage the configu-
ration button must be pressed. When this is done, the new module will be
assigned an address.
4.7 Device Status
The individual SmartWire-DT modules indicate their device status with the
aid of a diagnosis LED. The diagnostics LED can have the following states:
Table 9: Diagnostic messages of the SmartWire-DT status LED
4.8 Parameterization
Depending on the coordinator being used, the module's parameters will
need to be configured in the programming system or in the SWD-Assist plan-
ning and commissioning program.
DANGER
The exchange of the SmartWire-DT module PKE-SWD-32 must
only be carried out with the supply switched off.
ACHTUNG
The order of the SmartWire-DT units must not be altered.
DANGER
The exchange of the motor starter or contactor must only be
carried out after the complete system SmartWire-DT is
switched off.
Designation Color State Message
Ready Orange Continuous light Switching command for contactor via SmartWire-DT
Flashing Communication to the PKE is interrupted, switch command for
contact is present via SmartWire-DT
Green Continuous light Device is operating error-free.
Flashing (1 Hz) • Addressing process in progress
• after gateway power On
• after actuation of the configuration button on the gateway
• Module not in current configuration
• invalid type
Flashing (3 Hz) • Incorrect manual/automatic switch setting
• Communication to PKE is interrupted
To Next Page
Loading...
