Eaton SmartWire-DT SWD Series - DOL Starter

3 Switching on DIL-SWD-32-001, DIL-SWD-32-002 contactors
3.3 Engineering
68 SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com
3.3.1 DOL starter
The DOL starter is assembled from a PKZM0 and a contactor DILM7 to
DILM32. The SmartWire module for DILM is mounted on the contactor. The
SmartWire-DT module for DILM is mounted on the contactor.
ATTENTION
The sum of the pull-in power of the simultaneously tripping con-
tactors and the sum of the holding power of the tripped contac-
tors for each SmartWire-DT network must not exceed 72 W. If
required, an additional power feeder module (EU5C-SWD-PF1-1,
EU5C-SWD-PF-2) must be used
(￫ Chapter 1 “EU5C-SWD-PF1-1, EU5C-SWD-PF2-1 power
modules”, page 15)
￫
The DIL modules draw their energy for the communication elec-
tronics and for activation of the LEDs and of the auxiliary con-
tacts from the SmartWire-DT network supply. Please take into
consideration the total power consumption of your SmartWire-
DT network and, if necessary, plan for an additional feeder mod-
ule EU5C-SWD-PF2-1.
￫
For data for the current requirement please refer to the table in
the appendix on Page 253.
DIL-SWD-32-001 DIL-SWD-32-002
Figure 27: Connections of the SmartWire-DT module
DIL-SWD-32-001 or DIL-SWD-32-002 for DILM
a Connection of SmartWire-DT external device plug
b Mechanical switching position indicator
c Diagnostics LED
d Catch slider
e Connection pins
f Adjusting slide for contactor size
g Terminal X0-X1-X2
h Terminal, electrical enable X3-X4
i Selector switch 1-0-A
a
c
b
d
g
f
e
h
a
c
b
d
g
f
e
h
i