Eaton SmartWire-DT SWD Series User Manual

2 I/O modules EU5E-SWD…
2.13 Analog module EU5E-SWD-2A2A
56 SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com
The module is parameterized through its associated parameter byte in the
control configurator.
For values other than the default, change these values as shown below.
Structure of parameter byte 1:
Bit Function Configuration
0 Sensor selection
Input 1
0 = Voltage
1 = Current
1
Sensor selection
Input 2
0 = Voltage
1 = Current
2
Sensor selection
Output 1
0 = Voltage
1 = Current
3
Sensor selection
Output 2
0 = Voltage
1 = Current
4 , 5
Reading refresh rate Bit 5
0
0
1
1
Bit 4
0
1
0
1
= 20 ms
= 100 ms
= 200 ms
= 500 ms
6
Mean value 0 = off
1 = on
7
reserved 0
Bold values indicate the default settings.
￫
The CANopen field bus transmits data event-controlled when-
ever the reading changes. Reducing the reading refresh rate, for
example to 20 ms, can increase data traffic on the field bus.

Eaton SmartWire-DT SWD Series Specifications

General

Brand	Eaton
Model	SmartWire-DT SWD Series
Category	Control Unit
Language	English