To Next Page

To Previous Page

WaveRIDER 15

6) Click the Auto command button to have the software automatically find the COM

port the M.O.L.E. is connected. If the M.O.L.E. is not detected, there is a

communication problem (Refer to section 6.0 Service and Calibration for help).

Figure 2- 9: Port Configuration Dialog Box

7) Click the OK command button to finish.

Questions and Answers:

Need help?

Do you have a question about the ECD WaveRIDER Series and is the answer not in the manual?

ECD WaveRIDER Series Specifications

General