WaveRIDER vii
y Terms used in this Manual
ECD. introduced the original M.O.L.E. (Multichannel Occurrent Logger Evaluator) in
1986. Over the years ECD has produced several models of the M.O.L.E. for use in a
wide variety of applications. In this manual, we may refer to the SuperM.O.L.E. Gold
data recording device as the M.O.L.E..
Informs the user that the note includes important information.
Informs the user that the note includes a handy tip.
The following statements describe special terms that will be used in this manual.
Hardware Terms:
Informs the user that the note identifies conditions or practices that
could result in damage to the equipment.
Informs the user that the note identifies conditions or practices that
could result in personal injury or damage to property other than the
equipment.
WARNING – Surfaces may be Hot!
SuperM.O.L.E. Gold, may be referred as the M.O.L.E..
WaveRIDER Ready refers to the M.O.L.E. being configured to collect wave solder
data when used with the WaveRIDER kit.
Thermocouple, may be referred to as T/C.
Software Terms:
WaveRIDER SPC software may be referred to as WR SPC.
Workbook, contains all of the worksheets and the uploaded data set saved with file
extension (.MWR).
Worksheet, the individual pages or sheets in the workbook file.
Data Set, multiple data runs uploaded into the workbook file.
Data Run / Experiment, the data uploaded from the M.O.L.E..
To Next Page
Loading...
Need help?
General
