Ecotech Serinus 30 - Page 239

Serinu s 3 0 Ben utzer han dbuch 2 .1
Seite 120
Beschreibung
Anmerkungen
Analogue input 6
AMBIENT PRESSURE
Analogue input 7
RAW ADC CALIBRATION INPUT
Analogue input 8
MFC1 NOT USED
Analogue input 9
CONCENTRATION DATA
Analogue input 10
MFC2 NOT USED
Analogue input 11
MFC3 NOT USED
Analogue input 12
EXTERNAL ANALOG INPUT 0
Analogue input 13
EXTERNAL ANALOG INPUT 1
Analogue input 14
EXTERNAL ANALOG INPUT 1
Analogue input 15
MFC0 NOT USED
CO Measure Pot : Coarse
S30 Measure ZERO Coarse adjustment Pot
CO Measure Pot: Fine
S30 Measure ZERO Fine adjustment Pot
SO
2
Measure SIGNAL Gain Pot
SO
2
Measure Signal Gain Pot
SO
2
REFERENCE Gain Pot
SO
2
Reference Signal Gain Pot
SO
2
SIGNAL ZERO
SO
2
Measure Zero Pot
O
3
SIGNAL GAIN POT
O
3
INPUT SIGNAL GAIN POT
Test Pot
Test Pot for all the analysers
NO
X
Signal GAIN Pot
PMT signal input gain control FOR NOX
PGA Gain
1, 2, 4, 8, 16, 32, 64, 128
Primary Gas Concentration
Current value on front screen
Secondary Gas Concentration
Current value on front screen (if applicable eg NO
x)
Calculated Gas Concentration
Gas 3 (eg:NO
2
)
Primary Gas Average
Average of the readings(for Gas1) of the last n minutes where
n is the averaging period
Secondary Gas Average
Calculated Gas Average
Instrument Gain
Main Gas ID
Aux Gas ID
Decimal Places
2-5
Noise
Gas 1 Offset
Gas 3 Offset
Flow Temperature
Lamp Current
Digital Supply Voltage
Digital Supply voltage (should always read close to 5 volts)
Concentration Voltage
PMT High Voltage
High Voltage reading for PMT