Ecotech Serinus 30 - English; Default Chapter; Table of Contents

TÜV Rheinland Energie und Umwelt GmbH
Air Pollution Control
Report on the performance testing of the Serinus 30 ambient air quality moni-
toring system manufactured by Ecotech Pty Ltd measuring CO,
Report no.: 936/21221977/D_EN
Page 5 of 253
EP_Ecotech_Serinus30_en.docx
Contents
1. SUMMARY AND CERTIFICATION PROPOSAL ...........................................................11
1.1 Summary .......................................................................................................................11
1.2 Certification proposal .....................................................................................................12
1.3 Summary of test results .................................................................................................13
2. TASK DEFINITION ........................................................................................................22
2.1 Nature of the test ...........................................................................................................22
2.2 Objective .......................................................................................................................22
3. DESCRIPTION OF THE ANALYSER TESTED .............................................................23
3.1 Measuring principle .......................................................................................................23
3.2 Analyser scope and set-up ............................................................................................26
4. TEST PROGRAMME ....................................................................................................33
4.1 General .........................................................................................................................33
4.2 Laboratory test ..............................................................................................................33
4.3 Field test ........................................................................................................................34
5. REFERENCE MEASUREMENT METHOD ...................................................................35
6. TEST RESULTS ACCORDING TO VDI 4203 SHEET 3 ................................................36
6.1 4.1.1 Measured value display ....................................................................................36
6.1 4.1.2 Easy maintenance ...........................................................................................37
6.1 4.1.3 Functional check ..............................................................................................38
6.1 4.1.4 Set-up times and warm-up times ......................................................................39
6.1 4.1.5 Instrument design ............................................................................................40
6.1 4.1.6 Unintended adjustment ....................................................................................41
6.1 4.1.7 Data output ......................................................................................................42
6.1 5.1 General ...............................................................................................................43