Edwards nEXT730D User Manual

An air cooler can be ed to the pump - r
efer to Forced air cooling on page 64 to check
the suitability of air cooling in a parcular applicaon. The air coolers are pre-wired to
Vent Opon 2 and the default is set to Always On (opon 8).
Table 38 Air cooler
Air Cooler
Current draw Item number
nEXT730/930D Air cooler kit 150 mA B8J200800
nEXT1230H Air cooler kit 150 mA B8J200801
14.2 Water cooler
A water cooler can be ed to the nEXT730/930D pump if the water supply is suitable.
The nEXT1230H pump has a built-in water cooler.
Refer to Forced air cooling on page 64 to check the suitability of the water cooling
supply.
Table 39
Water cooler
Water Cooler
Item Number
nEXT730/930D water cooler B8J200820
14.3 Flange heater
A nEXT ange heater accelerates the degassing of the pump to enable it to achieve
lower pressures. It may also be used to protect the pump from condensaon of
contaminants. The ange heaters are available in 110 V and 240 V versions.
Note:
The ange heater is only f
or use with CF variants.
Table 40 Flange heater
Flange heater
Item Number
nEXT730D (110 V) ange heater B58052775
nEXT730D (240 V) ange heater B58052776
nEXT930D (110 V) ange heater on request
nEXT930D (240 V) ange heater on request
nEXT1230H (110 V) ange heater on request
nEXT1230H (240 V) ange heater on request
14.4 TAV5 and TAV6 vent valves
24 V d.c. TAV5 and TAV6 solenoid-operated vent valve opons available for system
venng; these are either normally open (N/O) or normally closed (N/C).
The valves are available with either a wired connector which connects directly to the
auxiliary port on the controller or as a bare wire opon.
08/2021 - ©Edwards Limited
Page 110B8J200880_D
300812671_002_C3
B8J200880_D - Accessories

Edwards nEXT730D Specifications

General

Brand	Edwards
Model	nEXT730D
Category	Water Pump
Language	English