Edwards nEXT730D - Timer Setting and Options

The reply will be as follows:
Command
* S 8 5 6 sp r cr
The normal speed is now stored in memory within the nEXT pump.
To check wha
t normal speed is set, send a query as follows:
Command
? S 8 5 6 cr
The reply will be as follows:
Reply
= S 8 5 6 sp d d d cr
6.1.8 Timer seng and opons
The meout period is a user-congurable opon and can be set to any value from
1 to 30 minutes.
When the pump is shipped, it is congured with a default meout period of 8 minutes.
Refer to Timer on page 16 for a full descripon of mer funconality.
To change the mer seng, send the following command (where the characters 'd'
represent the meout period in minutes):
Command
! S 8 5 4 sp d d cr
The reply will be as follows:
Reply
* S 8 5 4 sp r cr
The Timer seng is now s
tored in memory within the nEXT pump.
To check what me‑out period is set, send a query as follows:
Command
? S 8 5 4 cr
The reply will be as follows:
Reply
= S 8 5 4 sp d d cr
The mer is permanently enabled during r
amp‑up, however it is oponal whether to
have it enabled at other mes. When the pump is shipped, the Timer is enabled by
default.
To disable the mer, send the following serial command:
Command
! S 8 7 0 sp 0 cr
The reply will be as follows:
Reply
* S 8 7 0 sp r cr
The state of the mer opon is st
ored in memory within the nEXT pump.
To enable the mer again, send the following serial command:
Command
! S 8 7 0 sp 1 cr
The reply will be as follows:
Reply
* S 8 7 0 sp r cr
08/2021 - ©Edwards Limited
Page 71B8J200880_D
300812671_002_C3
B8J200880_D - Conguraon