Edwards nEXT730D User Manual

LED Descripon
Alarm LED
This red LED ashes in a sequence to indic
ate an error code if
a FAIL condion is prevenng pump operaon. The error co-
des can be used for fault nding as described in Fault nding
on page 96.
Serial Communicaons
Receive (Rx) LED
This yellow LED ashes briey whenever acvity is detected
on the serial link receive line and can be used for fault nding
the serial link.
Serial Communicaons
T
ransmit (Tx) LED
This yellow LED ashes briey
whenever the motor controller
is transming data on the serial link transmit line and can be
used for fault nding the serial link.
CAN Status LED
This bicolour (red and green) LED illuminates green when the
CAN communic
aon is good and acve, and red to indicate an
error prevenng CAN communicaon.
Bearing LED
This blue LED illuminates or ashes when a bearing service
acvity is due or ongoing. Refer to Table: Bearing LED.
Note:
If an ex
ternal electrical load is connected to the Normal output line, the normal LED may
illuminate.
08/2021 - ©Edwards Limited
Page 49B8J200880_D
300812671_002_C3
B8J200880_D - Technical data

Edwards nEXT730D Specifications

General

Brand	Edwards
Model	nEXT730D
Category	Water Pump
Language	English