Endress+Hauser iTEMP TMT162 - Max. Update Period; Squawk

iTEMP TMT162 Operating menu and parameter description
Endress+Hauser 111
Prerequisite: This parameter can only be selected if the Burst mode option is enabled.
Description Use this function to enter the minimum time span between two burst commands of burst
message X. The value is entered in the milliseconds unit.
User entry 500 to [value entered for the maximum time span in the Max. update period] parameter
as integers
Factory setting 1000
Max. update period
Navigation Expert → Communication → Burst configuration → Max. update period
Prerequisite: This parameter can only be selected if the Burst mode option is enabled.
Description Use this function to enter the maximum time span between two burst commands of burst
message X. The value is entered in the milliseconds unit.
User entry [Value entered for the minimum time span in the Min. update period] parameter to
3600000 as integers
Factory setting 2000
14.3.5 "Diagnostics" submenu
Detailed description
→  84
"Diagnose list" submenu
Detailed description
→  84
"Event logbook" submenu
Detailed description
→  86
"Device information" submenu
Device tag→  86
Navigation Setup → Device tag
Diagnostics → Device information → Device tag
Expert → Diagnostics → Device information → Device tag
Squawk
Navigation Expert → Diagnostics → Device information → Squawk