Operating menu and parameter description iTEMP TMT162
82 Endress+Hauser
SIL checksum
Navigation Setup → Advanced setup → SIL → SIL checksum
Description Displays the calculated SIL checksum.
The SIL checksum displayed can be used to check the device configuration. If 2
devices have identical configurations, the SIL checksum is also identical. This can
make for easy device replacement because if the checksum is the same, the device
configuration is guaranteed to be identical too.
Force safe state
Navigation Setup → Advanced setup → SIL → Force safe state
Prerequisite: The Operational state parameter displays SIL mode active.
Description During SIL proof testing this parameter can be used to test error detection of the device
current readback.
User entry • On
• Off
Factory setting Off
Deactivate SIL
Navigation Setup → Advanced setup → SIL → Deactivate SIL
Description Use this button to quit the SIL operating mode.
Restart device
Navigation Setup → Advanced setup → SIL → Restart device
Description Use this button to restart the device.
"Administration" submenu
Device reset
To Next Page
Loading...
