iTEMP TMT162 Operating menu and parameter description
Endress+Hauser 115
Options • No
• Yes
Factory setting No
"Simulation" submenu
Diagnostic simulation
Navigation Expert → Diagnostics → Simulation → Diagnostic simulation
Description Use this function to switch diagnostics simulation on and off.
Display If simulation is active, the relevant diagnostic event is displayed with the configured status
signal. → 36
User entry Off,
or a diagnostic event from the defined list of diagnostic events → 36
Factory setting Off
Current output simulation
→ 89
Navigation Diagnostics → Simulation → Current output simulation
Expert → Diagnostics → Simulation → Current output simulation
Value current output →
90
Navigation Diagnostics → Simulation → Value current output
Expert → Diagnostics → Simulation → Value current output
"Diagnostic settings" submenu
Diagnostic behavior
Navigation Expert → Diagnostics → Diagnostic settings → Diagnostic behavior
Description A certain event behavior is assigned at the factory to each diagnostic event in the
categories: sensor, electronics, process and configuration. The user can change this
assignment for certain diagnostic events via the diagnostic settings. → 37
To Next Page
Loading...
