Operating menu and parameter description iTEMP TMT162
70 Endress+Hauser
User entry A list of all the possible sensor types is provided in the "Technical data" section.→ 46
Factory setting Sensor type 1: Pt100 IEC751
Sensor type 2: No sensor
Connection type n
Navigation Setup → Connection type n
Expert → Sensor → Sensor n → Connection type n
Prerequisite: An RTD sensor must be specified as the sensor type.
Description Use this function to select the connection type for the sensor.
User entry • Sensor 1 (connection type 1): 2-wire, 3-wire, 4-wire
•
Sensor 2 (connection type 2): 2-wire, 3-wire
Factory setting • Sensor 1 (connection type 1): 4-wire
• Sensor 2 (connection type 2): none
2-wire compensation n
Navigation Setup → 2-wire compensation n
Expert → Sensor → Sensor n → 2-wire compensation n
Prerequisite: An RTD sensor with a 2-wire connection type must be specified as the sensor type.
Description Use this function to specify the resistance value for two-wire compensation in RTDs.
User entry 0 to 30 Ohm
Factory setting 0
Reference junction n
Navigation Setup → Reference junction n
Expert → Sensor → Sensor n → Reference junction n
Prerequisite: A thermocouple (TC) sensor must be selected as the sensor type.
To Next Page
Loading...
