Proline Prowirl R 200 HART Diagnostics and troubleshooting
Endress+Hauser 163
Parameter Description User interface Factory setting
Device revision Shows the device revision with which the
device is registered with the HART
Communication Foundation.
2-digit hexadecimal number 0x03
Device ID Shows the device ID for identifying the
device in a HART network.
6-digit hexadecimal number –
Device type Shows the device type with which the
measuring device is registered with the
HART Communication Foundation.
2-digit hexadecimal number 0x0038 (for Prowirl 200)
Manufacturer ID Shows the manufacturer ID device is
registered with the HART Communication
Foundation.
2-digit hexadecimal number 0x11 (for Endress+Hauser)
12.11 Firmware history
Release
date
Firmware
version
Order code for
"Firmware
version"
Firmware changes Documentation type Documentation
01.2018 01.03.zz Option 72 • Support for "mass vortex" order
option
• Upgrade to Heartbeat
Technology application package
• Permanent activation of natural
gas, air and industrial gases
application packages
• Extension of low flow cut off
• Extension of measuring range
for steam
Extension of two-phase
measurement
Operating Instructions BA01688D/06/EN/01.18
It is possible to flash the firmware to the current version or the previous version using
the service interface.
For the compatibility of the firmware version with the previous version, the installed
device description files and operating tools, observe the information about the device
in the "Manufacturer's information" document.
The manufacturer's information is available:
• In the Download Area of the Endress+Hauser web site: www.endress.com →
Downloads
• Specify the following details:
– Product root: e.g. 7F2C
The product root is the first part of the order code: see the nameplate on the
device.
– Text search: Manufacturer's information
– Media type: Documentation – Technical Documentation
To Next Page
Loading...
