Endress+Hauser Proline Prowirl R 200 - Setting the System Units

Commissioning Proline Prowirl R 200 HART
76 Endress+Hauser
1
XXXXXXXXX
A0029422
 24 Header of the operational display with tag name
1 Tag name
Enter the tag name in the "FieldCare" operating tool →  67
Navigation
"Setup" menu → Device tag
Parameter overview with brief description
Parameter Description User entry Factory setting
Device tag Enter the name for the measuring point. Max. 32 characters, such as
letters, numbers or special
characters (e.g. @, %, /).
Prowirl
10.4.2 Setting the system units
In the System units submenu the units of all the measured values can be set.
Depending on the device version, not all submenus and parameters are available in
every device. The selection can vary depending on the order code.
Navigation
"Setup" menu → System units
‣
System units
Volume flow unit
→  77
Volume unit
→  77
Mass flow unit
→  77
Mass unit
→  77
Corrected volume flow unit
→  77
Corrected volume unit
→  77
Pressure unit
→  78
Temperature unit
→  78
Energy flow unit
→  78