Endress+Hauser Proline Prowirl R 200 - Carrying out a Sensor Adjustment

Commissioning Proline Prowirl R 200 HART
112 Endress+Hauser
Parameter Prerequisite Description Selection / User
entry
Factory setting
2nd temperature delta heat The 2nd temperature delta
heat parameter is visible.
Enter 2nd temperature value
to calculate the delta heat.
Dependency
The unit is taken from the
Temperature unit parameter
–200 to 450 °C 20 °C
Fixed process pressure The following conditions are
met:
• Order code for "Sensor
version",
– Option "Mass flow
(integrated temperature
measurement)"
or
– Option "Mass flow
(integrated pressure/
temperature
measurement)"
• In the External value
parameter (→  83) the
Pressure option is not
selected.
Enter fixed value for process
pressure.
Dependency
The unit is taken from the
Pressure unit parameter.

For detailed information
on the calculation of the
measured variables with
steam: →  132
0 to 250 bar abs. 0 bar abs.
10.5.3 Carrying out a sensor adjustment
The Sensor adjustment submenu contains parameters that pertain to the functionality of
the sensor.
Navigation
"Setup" menu → Advanced setup → Sensor adjustment
‣
Sensor adjustment
Inlet configuration
→  113
Inlet run
→  113
Mating pipe diameter
→  113
Installation factor
→  113