Epson RC700 Series - Page 293

Maintenance 9. Troubleshooting
RC700 / RC700-A Rev.23 281
No.
Message
Remedy
Note 1
Note 2
7523
The specified vision sequence
already exists.
Change the sequence name.
Delete the existing sequence in
advance.
7524
The specified vision object already
exists.
Change the object name.
Delete the existing sequence in
advance.
7525 Cannot load vision project.
The project folder may be corrupt.
Restore backup data.
7526 Cannot save vision project.
The project folder may be
write-protect.
Check the access permission for the
project folder.
7527 Vision processor. Critical error.
Initialize the camera.
Rebuild the project.
7528
Image file not found.
Check the image file.
7529
Camera does not exist.
Check the camera connection.
7530
Acquisition failed.
Check the camera connection.
7531
No objects to train.
Teach the model.
7532
Cannot load image file.
Check the image file.
7533
Camera is not supported by
RC+7.0.
SC300/SC1200 is not supported by
RC+7.0.
Use CV1/CV2.
7534
Camera firmware does not support
new functions of RC+7.0.
Update the camera firmware.
7535
Invalid data from network camera.
Initialize the camera.
7536
Network camera export status
failed
Initialize the camera.
7537
Invalid ImageSize value. The
specified value is not supported by
the camera.
ImageSize exceeding the camera
resolution cannot be specified.
Correct the property value.
7538
Invalid ZoomFactor. The specified
value requires data outside of the
image area.
Settable values are from 0.1 to 10.0.
Correct the property value.
7539
The camera does not support Code
Reader.
Update the camera firmware.
7540
The camera does not support OCR.
Update the camera firmware.
7541 Insufficient data for teaching model.
Black or white image cannot be
registered as a model.
7542
Model window cannot be outside of
image.
Correct the position of the model
window.
7543
Calibration points have not been
taught.
Teach the calibration point.
7544 Calibration must be fixed upward.
Sequence with the calibration data of
the upward fixed camera is only
settable.
7545
Point was not defined.
Teach the calibration point.
7546
RobotPlacePos has not been
calibrated.
Click CalRobotPlacePos and
calibrate RobotPlacePos.
7547
Camera IP address is out of current
subnet.
Correct the camera IP address.
7548
Camera was not detected.
Check the wiring of the camera.
7549
Invalid Radius. Radius must be
>= RadiusInner and <=
RadiusOuter.
Correct the property value.
7550
OCR character does not exist.
Register the OCR character.
7551
OCR option is not active.
Enable the option.