Epson RC700 Series - Page 296

Maintenance 9. Troubleshooting
284 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
7712 Invalid axis specified.
Check whether the specified axis is
valid. Check if the axis is specified
correctly.
7713
Option not enabled
Enable the option.
7714
File not found.
Specify the correct file name.
7715
Robot number is out of the available
range.
Check the robot number.
7716 Robot does not exist.
Check whether the robot is
registered.
7717
File Error. Invalid folder.
Check the folder name.
7718 Cannot write the file.
Check the storage or the write
authority.
7750 Simulator. Initialization failure. Reboot RC+.
7751 Simulator. Failed to save the objects. Reboot RC+.
7752 Simulator. Failed to load the objects. Reboot RC+.
7753
Simulator. Failed to mapping of
memory.
Reboot RC+.
7754
Simulator. The virtual controller
already exists.
Name of the virtual controller may
be duplicated. Check the controller
name.
7755
Simulator. Failed to create the virtual
controller connection information.
Reboot RC+.
7756
Simulator. The copy source of the
virtual controller does not exist.
Check the virtual controller name.
7757
Simulator. The copy destination of
the virtual controller already exists.
Name of the virtual controller may
be duplicated. Check the controller
name.
7758
Simulator. Failed to copy the virtual
controller connection information.
Reboot RC+.
7759
Simulator. Failed to delete the virtual
controller connection information.
Reboot RC+.
7760
Simulator. Failed to delete the
controller connection information.
Reboot RC+.
7761
Simulator. Failed to rename the
controller connection information.
Check the virtual controller name.
7762
Simulator. The rename source of the
virtual controller does not exist.
Check the virtual controller name.
7763
Simulator. The rename destination of
the virtual controller already exists.
Check the virtual controller name.
7764 Simulator. Invalid Robot number. Reboot RC+.
7765
Simulator. Failed to read the Robot
definition file.
Check if the definition file exists.
7766
Simulator. Failed to copy the layout
objects.
Reboot RC+.
7767
Simulator. Failed to cut the layout
objects.
Reboot RC+.
7768
Simulator. Failed to paste the layout
objects.
Reboot RC+.