Essemtec Paraquda - 1 Safety; 1.1 Introduction; 1.2 Use of the Equipment

Paraquda Startup & Safety © Essemtec AG
1-1
0000003/11 / November 4, 2014
1 Safety
1.1 Introduction
1.1.1 Compulsory Reading
This Chapter is compulsory reading matter for anyone working with or at the Paraquda. Essemtec
AG declines all responsibility for personal injuries or material damages occurring as a result of non-
observance of this chapter's instructions and warnings.
1.2 Use of the Equipment
1.2.1 Intended Use
This ESSEMTEC Paraquda is purpose-built for the following operations:
• placement of SMD (Surface Mounted Devices) components on a PCB (Printed Circuit Board)
• dispensing of Glue or Solder Pastes
Operations other than the intended use are not permitted. ESSEMTEC assumes no responsibility for
any damages caused by using this machine for other purposes.
In case of any safety
-relevant alteration of the equipment or its behaviour, the equipment
must be taken out of service immediately and the defect has to be reported to the
respon
sible department or person.
1.2.2 Prohibited Use
Not known at issue date.
1.2.3 Modifications
It is forbidden to make any software or hardware modifications or extensions to the Paraquda. All
modifications require the written consent of the equipment's manufacturer.