Essemtec Paraquda - Page 6

Contents
vi © Essemtec AG Paraquda Startup & Safety
0000003/11 / November 4, 2014
4.4.4 Component pick up was not successful ............................................................................................................... 4-38
4.4.5 Jumping components during feed ......................................................................................................................... 4-39
4.4.6 Tape jam on feeder ....................................................................................................................................................... 4-39
4.4.7 Pick position covered with cover tape .................................................................................................................. 4-40
4.4.8 Component get lost during movement................................................................................................................ 4-40
4.4.9 Component vision inspection failed ...................................................................................................................... 4-41
4.4.10 Components visible on GUI, but missing on PCB .............................................................................................. 4-42
4.4.11 Tray could not be loaded by tray changer ........................................................................................................... 4-42
4.5 Set up the Production ................................................................................................................................................. 4-44
4.5.1 Define a Job ..................................................................................................................................................................... 4-47
4.5.2 Assign Components to the Feeder ......................................................................................................................... 4-48
4.5.3 Assign Medium to Dispense Valves ........................................................................................................................ 4-50
4.5.4 Set up and Connect the Feeders ............................................................................................................................. 4-54
4.5.5 Optimize the Process ................................................................................................................................................... 4-55
4.5.6 Check the Setup ............................................................................................................................................................. 4-55
4.5.7 Change over a Product................................................................................................................................................ 4-56
4.6 Teach a Recipe ................................................................................................................................................................ 4-56
4.6.1 Define Components ..................................................................................................................................................... 4-56
4.6.2 Define Dispense Components.................................................................................................................................. 4-61
4.6.3 Configure Feeders ......................................................................................................................................................... 4-64
4.6.4 Edit/Convert CAD Data ...............................................................................................................................................
4-65
4.6.5 Generate a Recipe ......................................................................................................................................................... 4-72
4.6.6 Generate a Panel Recipe ............................................................................................................................................. 4-74
4.6.7 Set up Head Barcode Reader .................................................................................................................................... 4-75
4.6.8 Set up Label / Label Feeder ....................................................................................................................................... 4-77
5 Install and Configure Software 5-1
5.1 Install new Software or Updates ................................................................................................................................ 5-1
5.2 Configure Directories (Paths) ...................................................................................................................................... 5-2
5.3 Configure Network Drives ............................................................................................................................................ 5-4
5.4 Configure the User Management .............................................................................................................................. 5-5
5.5 Organize the Option Management .......................................................................................................................... 5-7
5.6 Recover the System ........................................................................................................................................................ 5-8
6 Material Safety Data Sheet (MSDS) 6-1
6.1 Loctite 638 ......................................................................................................................................................................... 6-1