Operating of the Machine
4-18 © Essemtec AG Paraquda Startup & Safety
0000003/11 / November 4, 2014
Change Tape and Reel of components which are off
der out and lift it slightly to remove.
Removing can be done even if the
production is running as long as no
feeder lane is blinking on the feeder to
remove (if blinking, the P&P will access
the lane during the next cycle).
e spool with the winded
Pull apart the magnetic held cover tape spool.
Remove the winded cover tape and cut it up.
Pull the remaining tape out of the machine
To Next Page
Loading...
