EXFO Power Blazer - eCPRI BERT

Test Setup - Test Applications
Power Blazer 91
eCPRI BERT
eCPRI BERT
The eCPRI BERT test application allows the generation and analysis of
Framed eCPRI flow using eCPRI messages carried over Ethernet (L2) or
Ethernet/IP/UDP (L3/L4) allowing measurements of bit errors/pattern loss
based on a PRBS test pattern as well as quality of service metrics such as
One-Way or Round-Trip Latency, Jitter, Frame Loss, Out-of-Sequence, and
Throughput. It also supports a configurable test pattern when an unframed
signal is used to determine the presence of Bit Error or Pattern Loss on a
fiber link used to carry eCPRI signals.
 Typical eCPRI BERT test applications:
Network
under test
Testing Unit Testing Unit
EXFO Unit
Unframed,
Framed L2
EXFO Unit
Network
under test
Testing Unit Physical Loopback
EXFO Unit
Unframed
Network
under test
Testing Unit
EXFO Unit
Framed L2
Testing Units
EXFO Unit