EXFO Power Blazer - CFP;OSFP;QSFP;SFP

Test Setup - Test Configurator, Timer, and System
164 88000 Series
CFP/OSFP/QSFP/SFP
CFP/OSFP/QSFP/SFP
This tab gives hardware information related to the inserted transceiver
module.
From the Test menu, tap Setup, Test Configurator, tap on the interface
block or on the Local block for iSAM, and on the CFP/OSFP/QSFP/SFP tab.
Port, FlexO Instance ID, and FlexE PHY Number
Note: Only available with FlexE/FlexO BERT test application.
 Port allows selecting the physical port to be displayed.
 FlexO Instance ID indicates the FlexO instance identifier assigned to
the port.
 FlexE PHY Number indicates the FlexE PHY number assigned to the
port.
Parameters
The following parameters are retrieved from the transceiver:
Parameter CFP4 CFP8
QSFP+
QSFP28
QSFP56-DD
OSFP
SFP
SFP+
SFP28
Module ID
a
XX X X
Vendor Name XX X X
Part Number XX X X
Serial Number XX X X
Hardware Revision XX X X
Firmware Version XX - -
Revision Compliance --X -