EXFO Power Blazer - Port Availability per Module

Physical Interfaces and LEDs
Power Blazer 25
Port Availability per Module
Port Availability per Module
88200NGE
The following table shows the list of available ports as well as a description
and the signals supported on the module.
Port
Labelled
Description Supported Signal(s)
SFP+ Optical IN/OUT port SFP/SFP+
transceiver
Ethernet 100/1000 Mbit/s, 10 Gbit/s optical
Ethernet 10/100/1000 Mbit/s electrical (using active copper SFP)
Fibre Channel 1X, 2X, 4X, 8X, 10X, 16X
eCPRI 10 Gbit/s
CPRI 1.2, 2.4, 3.1, 4.9, 6.1, 9.8, 10.1 Gbit/s
OBSAI 1.5, 3.1, 6.1 Gbit/s
OC-1/STM-0, OC-3/STM-1, OC-12/STM-4, OC-48/STM-16,
OC-192/STM-64
OTU1, OTU2, OTU1e, OTU2e, OTU1f, OTU2f.
CFP4 Optical IN/OUT port CFP4
transceiver
a
a. Only OTU4 (4 Lanes) and 100GE (4 Lanes) are supported.
Ethernet 100 Gbit/s
OTU4
QSFP
(QSFP+ or
QSFP28)
Optical IN/OUT port QSFP+
transceiver
b
b. Only parallel interfaces are supported.
Ethernet 40 Gbit/s
OTU3e2, OTU3e1, OTU3
Optical IN/OUT port QSFP28
transceiver
a
Ethernet 100 Gbit/s
OTU4
REF OUT Electrical port SMA for eye
diagram clock signal
generation
EXT CLK Electrical port SMB for
external clock synchronization
DS1/1.5M, E1/2M, 2MHz, 1PPS
c
c. Available for Dual Test Set - One-Way Latency measurement mode.