EXFO Power Blazer - Service Configuration - L2 CP

Test Results
522 88000 Series
Service Configuration - L2CP
Service Configuration - L2CP
From the Test menu, tap Results, Service Configuration, and the L2CP
tab.
Service Name and Selection
Service Name indicates the name of the selected service.
Select the service to be displayed by either using the left/right arrow or by
tapping over the service numbers area then tapping on a specific service
number. An orange background indicates the selected service while a
green background indicates the services that are enabled.
L2CP Statistics per Service
 Name indicates the name of each L2CP frame.
 Dest. MAC indicates the L2CP frame destination MAC address.
 Expected L2CP Handling indicates the expected L2CP handling: Pass
Through or Discard/Peer.
 Direction indicates respectively results for local (L) and remote (R)
directions.
 TX Frames indicates the count of L2CP frames transmitted per
direction.
 RX Frames indicates the count of L2CP frames received per direction.