Test Functions
680 88000 Series
Packet Capture
Packet Capture
Capture is used to analyze all or filtered data traffic and save complete or
truncated frames into a buffer. It allows observing network truncated data
precisely, or understanding errors and unwanted behavior.
Note: Not available with 200/400G and eCPRI dual port topology.
From the Test menu, tap Functions, and the Packet Capture tab.
Note: For Dual Port topology select the port to be displayed.
Capture Source
Specifies what kind of data to be captured.
Interface captures all received frames and saves them in the capture
buffer.
Filter x captures only frames that match the selected filter and saves
them in the capture buffer. Select the filter number from the list. Only
enabled filters are available, see Filters on page 645.
The selected filter will be reserved for data capture and will not be
available for filter configuration.
To Next Page
Loading...
