Maintenance
748 88000 Series
Cleaning LC/MPO-n Connectors
Cleaning LC/MPO-n Connectors
Under normal circumstances the cleaning of the LC/MPO-n connector is
not required. However if the connector shows signs of debris or
contamination, cleaning may be required.
To clean a LC/MPO-n connector
1. Use a clean dry air (CDA) or a air gun to blow out the dust or
contamination.
2. Re-inspect the connector. For MPO-n optical connector, re-inspect the
connector under magnification to make sure that it is clean.
3. If the connector is still not clean, use a commercial cleaner
recommended by the transceiver manufacturer.
Note: Refer to the transceiver manufacturer for more detailed cleaning
recommendations and instructions.
Battery Safety Information
The TA/TA4-... transceiver systems contain a battery for the insertion
counter. If the battery status is low, contact your nearest authorized EXFO
service center for its replacement.
WARNING
Do not throw batteries into fire or water and do not short-circuit
the batteries’ electrical contacts. Do not disassemble.
To Next Page
Loading...
