Test Setup - Test Configurator, Timer, and System
198 88000 Series
EtherSAM - L2CP
EtherSAM - L2CP
From the Test menu, tap Setup, Test Configurator, tap on the test block,
and on the L2CP tab.
Frame Rate
Defines the rate of L2CP frames to be transmitted: 1 frame/s or 10 frame/s
(default).
Frame Count
Defines the quantity of each configured L2CP frame to be transmitted:
10 (default), 100, 1000 frames.
L2CP Frame Table
Lists predefined and user defined L2CP frames. Use the corresponding “...”
button to edit each L2CP frame individually.
For predefined L2CP frames, only the Name and Destination MAC Address
(frames having more than one allowed MAC Addresses) are configurable;
the other parameters are fixed along with their L2CP type. For user defined
frames, the following parameters are configurable at the exception of Type
and Subtype:
Name: Up to 20 characters are allowed. Default names are the type of
the L2CP frame for predefined frames and User 1/2/3/4 (01-80-C2)
and User 5/6/7/8 (01-00-0C) for user defined frames.
Type: Indicates the type of the L2CP frame for predefined frames and
User (01-80-C2) or User (01-00-0C) for user defined frames.
Frame Format: Ethernet II (default), LLC, or SNAP.
Frame Size: 64 bytes (default) to 1518 bytes. The frame size excludes
the VLAN encapsulation.
To Next Page
