EXFO Power Blazer - Page 209

Test Setup - Test Configurator, Timer, and System
Power Blazer 199
EtherSAM - L2CP
 Destination MAC Address: For predefined L2CP frames allows
selecting the Destination MAC Address for frames having more than
one allowed MAC Addresses. For user defined allows selecting the
Destination MAC Address from 01-80-C2-00-00-00 (default) to
01-80-C2-FF-FF-FF for User (01-80-C2) and from 01-00-0C-00-00-00
(default) to 01-00-0C-FF-FF-FF for User (01-00-0C).
 LLC (available with LLC and SNAP frame formats)
 SSAP: 0x00 to 0xFF (0x42 by default) for LLC frame format; fixed
to 0xAA for SNAP frame format.
 DSAP: 0x00 to 0xFF (0x42 by default) for LLC frame format; fixed
to 0xAA for SNAP frame format.
 Control: 0x00 to 0xFF (0x03 by default) for LLC frame format;
fixed to 0x03 for SNAP frame format.
Note: For LLC frame format, the following concatenated values of
DSAP/SSAP/Control are not valid since they are reserved for SNAP frame
format: 0xAAAA03 or 0xABAB03.
 OUI (available with SNAP frame format): 0x000000 (default) to
0xFFFFFF.
 EtherType (available with SNAP and Ethernet II frame formats):
0x0000 to 0xFFFF for SNAP and 0x0600 to 0xFFFF (excluding 0x8100,
0x88A8, 0x9100, 0x9200, 0x9300, 0x8847, and 0x8848) for Ethernet II.
Default is 0x0600.
 Subtype, only available for some predefined L2CP frames, indicates
the subtype for the frame.
 Custom Bytes (16 bytes) 0x00000000000000000000000000000000
(default) to 0xFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF. Only available
for user defined L2CP frames.