EXFO Power Blazer - BNC; SMB; LEDs

Physical Interfaces and LEDs
30 88000 Series
BNC
BNC
Connector type is BNC for coaxial 75-ohm cable connection. An adapter
cable (BNC to Bantam) is required for Bantam external clock connection
(not supplied).
SMB
The connector type is SMB for coaxial 75-ohm cable connection. An
adapter cable (SMB to Bantam) is required for Bantam connection (not
supplied).
LEDs
 LASER red LED is on when the module is emitting an optical laser
signal.
 LINK/RX green LED is on when the link is up, off when the link is down,
and flashing when frames are transmitted and/or received.
 DUPLEX green LED is on for Full Duplex mode, off for Half Duplex
mode, and flashing when collisions are detected.
 Port blue LED is on when this port is selected for the test, and flashing
when this port is selected for clock input.