Test Setup - Test Configurator, Timer, and System
166 88000 Series
Clients - Profile
Clients - Profile
From the Test menu, tap Setup, Test Configurator and tap on the Clients
block and on the Profile tab.
Client ID and Size (Gbit/s)
Note: Only available with FlexE BERT test application.
Client ID allows selecting the client ID to be displayed.
Size (Gbit/s) indicates the size of the client ID.
Ethernet Frame
Frame Size (Bytes) allows entering the frame size. The range is from 64 to
either 2000 for multiple clients or 10000 for a single client.
Shaping
TX Rate allows the selection of the transmission rate in Mbit/s or
Gbit/s.
Enable TX check box when selected (default) generates streams for
the selected client ID when the test is started while the TX button is
enabled (refer to Start/Stop|TX Button on page 741). The Enable TX
check box may also be selected or cleared while the test is running.
To Next Page
Loading...
