EXFO Power Blazer - FlexO;OTN

Test Setup - Test Configurator, Timer, and System
Power Blazer 213
FlexO/OTN
FlexO/OTN
From the Test menu, tap Setup, Test Configurator, the FlexO-OTUCn
protocol block, and FlexO/OTN tab.
Note: Only one client is supported in the FlexO Group.
FlexO
 FlexO Status indicates the global FlexO group status: up (green arrow)
or down (red arrow).
 FlexO Group ID indicates the FlexO group ID number.
OTUCn
 The OTUCn Test Signal table lists the following for each FlexO client:
 Client ID indicates the client identification number.
 Type indicates the ODUk container (client).
 Size (Gbit/s) indicates the the ODUk client size.
 Edit ID button allows editing the Client ID: 1 (default) to 40.
 OTUC4/ODUC4/ODUk represents the mapping of the signal.
 Payload Type indicates the payload type which is 22.
 Qty of Clients indicates the quantity of clients which is 1.
 Usage indicates that 80 tributary slot are used corresponding to 419
Gbit/s.