Selecting and Starting a Test
102 88000 Series
Sync Test Applications
4. Tap the Timer tab to automatically start and/or stop the test at a given
time or for a specific duration (refer to Timer on page 368). Not
supported with Wander test application.
5. For additional test configurations refer to Test Functions on page 611.
6. Tap the Start button from the right navigation bar to start the test (refer
to Start/Stop|TX Button on page 741). The Summary result page will
be automatically displayed when the test is started from any Setup
configuration page. For additional results refer to Test Results on
page 385.
7. Depending on the test, when the test ends automatically or manually
stopped, the generate report pop-up is displayed by default. If required,
tap Yes to generate a report of the test results and statistics (refer to
Report Button on page 731 for more information).
To Next Page
Loading...
