Test Setup - Test Configurator, Timer, and System
118 88000 Series
Test Configurator Overview
Protocol Block displays an overview of either the frame structure
and its parameters for Ethernet test applications or the embedded
signal for Transport test applications. This block is not present for
all tests. Tap on the protocol block to change the settings and to
see detailed status. For RFC 2544, EtherBERT, and Traffic Gen &
Mon in Dual Port topology, there is a protocol block for each port.
Test Block displays an overview of the test settings and status. Tap
on the test block to change the settings and to see detailed status.
Clock Block displays an overview of the clock settings and status.
Tap on the clock area to change the settings and to see detailed
status. For Dual Port topology, the clock block is not present but
the clock is set to Internal.
External Reference Block displays an overview of the external
reference signal settings and status. Tap on the external reference
area to change the settings and to see detailed status.
To Next Page
