Test Setup - Test Configurator, Timer, and System
146 88000 Series
Modify Structure Button
Emulation Mode is available with CPRI/OBSAI Framed L2
Base Station (default) is used to validate the connectivity with the
RRH.
For CPRI, it initiates the start-up sequence and provides
synchronization with the RRH.
For OBSAI, it initiates the State Machine events and provides
synchronization with the RRH.
Remote Radio Head is used to validate the communication with a
base station.
For CPRI, it begins its start-up sequence when it detects a valid
signal from the base station.
For OBSAI, the State Machine events depend on the Base Station
signal transmission.
Topology allows the selection of the network test topology:
Single Port (default) or Dual Port (available with CPRI and eCPRI
Framed Layer 2/3/4 (88260 only).
To Next Page
