Test Setup - Test Configurator, Timer, and System
Power Blazer 227
Interface
For Fibre Channel test application:
PSP (Link Protocol) (Primitive Sequence Protocol) check box when
selected (default) allows link management by activating the port.
For CPRI Unframed test application:
Scrambling check box when selected (default) enables the scrambler.
Only available with CPRI rates 4.9152 Gbit/s and higher.
For CPRI Framed L2 test application:
Sequence indicates the last Startup Sequence State: Standby (A),
L1 Sync (B), Protocol (C), L2 C&M (D), Vendor (E), Operation (F),
or Passive (G). Frame Sync indicates the synchronization status: green
for active, red for inactive, or gray for pending.
Protocol defines how the CPRI Startup Sequence negotiates the
protocol version.
Auto can use protocol Version 1 and Version 2 during the
negotiation.
Version 1 negotiates the protocol with either Scrambling disabled
for all supported CPRI rates with the exception of 10.1 for which
the Scrambling is enabled.
Version 2 negotiates the protocol with Scrambling enabled.
Available with CPRI rates: 9.8, 6.1, and 4.9 Gbit/s.
Protocol table indicates either the last received (Version 1 or
Version 2) or negotiated (Auto) protocol version. A light-red
background indicates a Protocol version mismatch between the
received value and the expected generated value.
To Next Page
