EXFO Power Blazer - Page 272

Test Setup - Test Configurator, Timer, and System
262 88000 Series
MAC/IP/UDP
 Reliability allows the selection of the reliability level:
Normal (default) or High.
 Monetary Cost allows the selection of the monetary cost level:
Normal (default) or Low.
 Reserved Bit allows the selection of the reserved bit value:
0 (default) or 1.
Differentiated Services (available when DS is selected).
 DSCP Codepoints:
000000 (CS0) (default), 001000 (CS1), 010000 (CS2),
011000 (CS3), 100000 (CS4), 101000 (CS5), 110000 (CS6),
111000 (CS7), 001010 (AF11), 001100 (AF12), 001110 (AF13),
010010 (AF21), 010100 (AF22), 010110 (AF23), 011010 (AF31),
011100 (AF32), 011110 (AF33), 100010 (AF41), 100100 (AF42),
100110 (AF43), 101100 (VOICE-ADMIT), 101110 (EF),
110011 (51), 110110 (54), or User Defined.
 User Defined Codes, available when User Defined has been
selected from the DSCP codepoints, allows entering a user
defined code from hexadecimal 00 (default) to 3F once the
TOS/DS Config pop-up is closed.
 ECN allows the selection of the Explicit Congestion Notification
code: 00 (Not-ECT) (default), 01 (ECT-1), 10 (ECT 0), or 11 (CE).
UDP
Allows the selection of the source and destination UDP port number.
 Source Port is configurable from 0 to 65535; the default is 49184.
 Destination Port is configurable from 0 to 65535; the default is
7(echo).