Test Setup - Test Configurator, Timer, and System
278 88000 Series
Network Details (iSAM)
Customizable Performance Criteria
As previously mentioned, factory performance criteria are available and up
to 25 performance criteria can be defined by editing the performance
criteria text file (iSAMPerformanceCriteriaTemplate.ini) using a text editor
like Notepad. The file is located under
ProgramData\EXFO\ProtocolProducts\.
Example of performance criteria’s text file:
Each profile entry has the following parameters:
Performance Criteria Name: 1 to 16 characters. All ASCII characters
from 32 to 126 decimal are supported.
Frame Delay (FD) Threshold: 0.001 ms (0.005 ms for 10M) to 8000 ms.
Inter-Frame Delay (IFDV) Threshold: 0.001 ms (0.005 ms for 10M) to
8000 ms.
Frame Loss Ratio (FLR) Threshold: 0.00 % to 5.00 %.
If the threshold value for a parameter is not defined, it is considered as
disabled (as in the example above for IFDV =).
The value of a parameter is validated to ensure it is within the supported
range; otherwise the performance criteria entry is unsupported.
[MEF Metro High]
FD = 10
IFDV = 3
FLR = 0.01
[MEF Metro Med]
FD = 20
IFDV = 8
FLR = 0.01
[MEF Metro Low]
FD = 37
IFDV =
FLR = 0.1
To Next Page
