Test Setup - Test Configurator, Timer, and System
310 88000 Series
S-OAM and MPLS-TP OAM
MEG Level (Y.1731, MEF, and G.8113.1) is the Maintenance Entity
Group Level configurable from 0 to 7 (default).
MD Level (802.1ag) is the Maintenance Domain Level and is
configurable from 0 to 7 (default).
MEP ID is the Maintenance Entity Group End Point Identification
configurable from 0x0001 (default) to 0x1FFF.
Peer MEP Parameters
MAC Address, available with S-OAM Mode, allows entering the unique
Media Access Control (MAC) address of the peer MEP (default is
00:00:00:00:00:00).
MEP ID is the Maintenance Entity Group End Point Identification
configurable from 0x0001 (default) to 0x1FFF.
OAM Quick Ping verifies the bidirectional connectivity with the peer
MEP. The Successful message is reported when at least one of three
attempts has been successful otherwise Failed is reported.
Continuity Check
CC Function check box when selected (default) allows transmitting
and monitoring CCM frames.
The following parameters are only configurable when the CC Function
check box is cleared.
Address Type, available with S-OAM Mode, defines the destination
address type of the CCM frames: Unicast or Multicast (default).
Priority, available with S-OAM Mode or when VLAN is enabled (see
VLAN on page 268), allows selecting the VLAN user priority: 0 to 7
(default). Refer to VLAN ID and Priority on page 842 for more
information.
To Next Page
Loading...
